CISCO路由器配置手册三、虚拟局域网（VLAN）路由实例3.1. 例一：

设备选用Catalyst5500交换机1台，安装WS-X5530-E3管理引擎，多块WS-X5225R及WS-X5302路由交换模块,WS-X5302被直接插入交换机，通过二个通道与系统背板上的VLAN 相连，从用户角度看认为它是1个1接口的模块，此接口支持ISL。在交换机内划有3个虚拟网，分别名为default、qbw、rgw，通过WS-X5302实现虚拟网间路由。

以下加重下横线部分，如set system name  5500C为需设置的命令。

  设置如下：Catalyst 5500配置：  beginset password $1$FMFQ$HfZR5DUszVHIRhrz4h6V70set enablepass $1$FMFQ$HfZR5DUszVHIRhrz4h6V70set prompt Console>set length 24 defaultset logout 20set banner motd ^C^C!#systemset system baud  9600set system modem disableset system name  5500C set system locationset system contact !#ipset interface sc0 1 10.230.4.240 255.255.255.0 10.230.4.255   set interface sc0 upset interface sl0 0.0.0.0 0.0.0.0set interface sl0 upset arp agingtime 1200set ip redirect   enableset ip unreachable   enableset ip fragmentation enableset ip route 0.0.0.0 10.230.4.15 1 set ip alias default 0.0.0.0!#Command alias!#vtpset vtp domain hne set vtp mode server set vtp v2 disableset vtp pruning disableset vtp pruneeligible 2-1000clear vtp pruneeligible 1001-1005set vlan 1 name default type ethernet mtu 1500 said 100001 state active set vlan 777 name rgw type ethernet mtu 1500 said 100777 state active set vlan 888 name qbw type ethernet mtu 1500 said 100888 state active set vlan 1002 name fddi-default type fddi mtu 1500 said 101002 state activeset vlan 1004 name fddinet-default type fddinet mtu 1500 said 101004 state active bridge 0x0 stp ieeeset vlan 1005 name trnet-default type trbrf mtu 1500 said 101005 state active bridge 0x0 stp ibmset vlan 1003 name token-ring-default type trcrf mtu 1500 said 101003 state active parent 0 ring 0x0 mode srb aremaxhop 7 stemaxhop 7!#set boot commandset boot config-register 0x102set boot system flash bootflash:cat5000-sup3.4-3-1a.bin!#module 1 : 2-port 1000BaseLX Supervisorset module name    1   set vlan 1    1/1-2set port enable     1/1-2!#module 2 : empty!#module 3 : 24-port 10/100BaseTX Ethernetset module name    3   set module enable  3set vlan 1    3/1-22 set vlan 777  3/23 set vlan 888  3/24 set trunk 3/1  on isl 1-1005 #module 4 empty!#module 5 empty!#module 6 : 1-port Route Switchset module name    6   set port level      6/1  normalset port trap       6/1  disableset port name       6/1set cdp enable   6/1set cdp interval 6/1 60set trunk 6/1  on isl 1-1005 !#module 7 : 24-port 10/100BaseTX Ethernetset module name    7   set module enable  7set vlan 1    7/1-22 set vlan 888  7/23-24 set trunk 7/1 on isl 1-1005 set trunk 7/2 on isl 1-1005 !#module 8 empty!#module 9 empty!#module 10 : 12-port 100BaseFX MM Ethernetset module name    10  set module enable  10set vlan 1    10/1-12set port channel 10/1-4 offset port channel 10/5-8 offset port channel 10/9-12 offset port channel 10/1-2 onset port channel 10/3-4 onset port channel 10/5-6 onset port channel 10/7-8 onset port channel 10/9-10 onset port channel 10/11-12 on#module 11 empty!#module 12 empty!#module 13 empty!#switch port analyzer!set span 1 1/1 both inpkts disableset span disable!#camset cam agingtime 1-2,777,888,1003,1005 300end5500C> (enable)  WS-X5302路由模块设置：  Router#wri tBuilding configuration...  Current configuration:!version 11.2no service password-encryptionno service udp-small-serversno service tcp-small-servers!hostname Router!enable secret 5 $1$w1kK$AJK69fGOD7BqKhKcSNBf6.!ip subnet-zero!interface Vlan1  ip address 10.230.2.56 255.255.255.0 !interface Vlan777  ip address 10.230.3.56 255.255.255.0 !interface Vlan888  ip address 10.230.4.56 255.255.255.0 !no ip classless!line con 0line aux 0line vty 0 4 password router login!end  Router#  3.1. 例二：

交换设备仍选用Catalyst5500交换机1台，安装WS-X5530-E3管理引擎，多块WS-X5225R在交换机内划有3个虚拟网，分别名为default、qbw、rgw，通过Cisco3640路由器实现虚拟网间路由。交换机设置与例一类似。

路由器Cisco3640，配有一块NM-1FE-TX模块，此模块带有一个快速以太网接口可以支持ISL。Cisco3640快速以太网接口与交换机上的某一支持ISL的端口实现连接，如交换机第3槽第1个接口（3/1口）。  Router#wri tBuilding configuration...  Current configuration:!version 11.2no service password-encryptionno service udp-small-serversno service tcp-small-servers!hostname Router!enable secret 5 $1$w1kK$AJK69fGOD7BqKhKcSNBf6.!ip subnet-zero!interface FastEthernet1/0!interface FastEthernet1/0.1  encapsulation isl 1  ip address 10.230.2.56 255.255.255.0 !interface FastEthernet1/0.2 encapsulation isl 777  ip address 10.230.3.56 255.255.255.0 !interface FastEthernet1/0.3  encapsulation isl 888  ip address 10.230.4.56 255.255.255.0 !no ip classless!line con 0line aux 0line vty 0 4 password router login!end  Router#